Send documentation comments to mdsfeedback-doc@cisco.com
8-55
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fctimer
fctimer
To change the default Fibre Channel timers, use the fctimer command in configuration mode. To revert
to the default values, use the no form of the command.
fctimer {d_s_tov milliseconds [vsan vsan-id] | e_d_tov milliseconds [vsan vsan-id] | r_a_tov
milliseconds [vsan vsan-id]}
no fctimer {d_s_tov milliseconds [vsan vsan-id] | e_d_tov milliseconds [vsan vsan-id] | r_a_tov
milliseconds [vsan vsan-id]}
Syntax Description
Command Modes Configuration mode.
Command History
Usage Guidelines The Cisco MDS 9000, Brocade, and McData FC Error Detect (ED_TOV) and Resource Allocation
(RA_TOV) timers default to the same values. They can be changed if needed. In accordance with the
FC-SW2 standard, these values must be the same on each switch within in the fabric.
Use the vsan option to configure different TOV values for VSANs with special types of links like FC or
IP tunnels.
Examples The following examples show how to change the default Fibre Channel timers.
switch# config terminal
switch(config)# fctimer e_d_tov 5000
switch(config)# fctimer r_a_tov 7000
Related Commands
d_s_tov milliseconds Specifies the distributed services time out value. The range is 5000 to 100000
milliseconds.
e_d_tov milliseconds Specifies the error detect time out value. The range is 1000 to 100000
milliseconds, with a default of 2000.
r_a_tov milliseconds Specifies the resolution allocation time out value. The range is 5000 to
100000 milliseconds, with a default of 10000.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4096.
Release Modification
1.0(2) This command was introduced.
Command Description
show fctimer Displays the configured Fibre Channel timer values.
To Next Page
Loading...
Need help?
General