Send documentation comments to mdsfeedback-doc@cisco.com
22-265
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ntp
The following example displays the NTP IO statistics.
switch# show ntp statistics io
time since reset: 11152
receive buffers: 9
free receive buffers: 9
used receive buffers: 9
low water refills: 0
dropped packets: 0
ignored packets: 0
received packets: 3
packets sent: 2
packets not sent: 0
interrupts handled: 3
received by int: 3
The following example displays the NTP local statistics.
switch# show ntp statistics local
system uptime: 11166
time since reset: 11166
bad stratum in packet: 0
old version packets: 4
new version packets: 0
unknown version number: 0
bad packet format: 0
packets processed: 0
bad authentication: 0
The following example displays the NTP memory statistics information.
switch# show ntp statistics memory
time since reset: 11475
total peer memory: 15
free peer memory: 15
calls to findpeer: 0
new peer allocations: 0
peer demobilizations: 0
hash table counts: 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
The following example displays the NTP peer statistics information using the IP address of the peer.
switch# show ntp statistics peer ipaddr 10.1.1.1
The following example displays the NTP peer statistics information using the name of the peer.
switch# show ntp statistics peer name Peer1
The following example displays the NTP timestamp status information.
switch# show ntp timestamp-status
Linecard 9 does not support Timestamp check.
Related Commands Command Description
ntp Configures NTP parameters.
To Next Page
Loading...
