Send documentation comments to mdsfeedback-doc@cisco.com
11-126
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ivr copy auto-topology user-configured-topology
ivr copy auto-topology user-configured-topology
To copy the automatically discovered inter-VSAN routing (IVR) VSAN topology to the user configured
topology, use the ivr
copy auto-topology user-configured-topology command in EXEC mode.
ivr copy auto-topology user-configured-topology
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes EXEC configuration mode.
Command History
Usage Guidelines After using the ivr copy auto-topology user-configured-topology command to copy the automatically
discovered VSAN topology into the user configured topology you must use the ivr commit command to
apply the pending configuration changes to the IVR topology using Cisco Fabric Services (CFS)
distribution.
Examples The following example copies the automatically discovered VSAN topology into the user configured
topology.
switch# ivr copy auto-topology user-configured-topology
Related Commands
Release Modification
2.1(1a) This command was introduced.
Command Description
ivr commit Applies the changes to the IVR topology.
ivr copy active-topology
user-configured topology
Copies the active inter-VSAN routing (IVR) VSAN topology to the user
configured topology.
ivr copy active-zoneset
full-zoneset
Copies the active zone set to the full zone set.
show ivr vsan topology Displays the IVR VSAN topology configuration
To Next Page
Loading...
Need help?
General