Send documentation comments to mdsfeedback-doc@cisco.com
22-224
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ivr virtual-switch-wwn
show ivr virtual-switch-wwn
To display an inter-VSAN routing (IVR) virtual switch WWN, use the show ivr virtual-switch-wwn
command.
show ivr virtual-switch-wwn native-switch-wwn switch-wwn native-vsan vsan-id
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines The sWWN of the virtual switch must be present in the fabric binding database of all the VSANs where
the virtual switch is in use. If the sWWN is not in the database, you must add it before attempting to
implement FICON over IVR.
Examples The following example displays an IVR virtual sWNN.
switch# show ivr virtual-switch-wwn native-switch-wwn 20:00:00:0d:ec:00:8c:c0 native-vsan
1
virtual switch wwn : 20:01:00:0d:ec:00:8c:c1
Related Commands
native-switch-wwn
switch-wwn
Specifies the sWWN of the native switch. The format is in dotted hex.
native-vsan vsan-id Specifies the ID of the native VSAN. The range is 1 to 4093.
Release Modification
3.0(1) This command was introduced.
Command Description
show ivr Displays IVR information.
To Next Page
Loading...
Need help?
General