Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
20-19
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
read-only
read-only
To configure the read-only attribute in a zone attribute group, use the read-only command in zone
attribute configuration submode. To revert to the default, use the no form of the command.
read-only
no read-only
Syntax Description This command has no other arguments or keywords.
Defaults Read-write.
Command Modes Zone attribute configuration submode.
Command History
Usage Guidelines This command only configures the read-only attribute for enhanced zoning. To enable broadcast zoning
for basic mode, use the attribute read-only subcommand after entering zone configuration mode using
the zone name command.
Examples The following example shows how to set the read-only attribute for a zone attribute group.
switch# config terminal
switch(config)# zone-attribute-group name admin-attributes vsan 10
switch(config-attribute-group)# read-only
Related Commands
Release Modification
2.0(x) This command was introduced.
Command Description
show zone-attribute-group Displays zone attribute group information.
zone mode enhanced vsan Enables enhanced zoning for a VSAN.
zone name Configures zone attributes.
zone-attribute-group name Configures zone attribute groups.