Send documentation comments to mdsfeedback-doc@cisco.com
1-14
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 1 CLI Overview
Navigating Through CLI Commands
Using the no and Default Forms of Commands
You can issue the no form of any command to perform the following actions:
• Undo a wrongly issued command.
If you issue the zone member command, you can undo the results:
switch(config)# zone name test vsan 1
switch(config-zone)# member pwwn 12:12:12:12:12:12:12:12
switch(config-zone)# no member pwwn 12:12:12:12:12:12:12:12
WARNING: Zone is empty. Deleting zone test. Exit the submode.
switch(config-zone)#
• Delete a created facility
If you want to delete a zone that you created:
switch(config)# zone name test vsan 1
switch(config-zone)# exit
switch(config)# no zone name test vsan 1
switch(config)#
You cannot delete a zone facility called test while residing in it. You must first exit the zone submode
and return to configuration mode.
Port Names and Port Mapping
The Cisco Fabric Switch for HP c-Class BladeSystem has a different port naming convention from the
Cisco MDS 9000 Family. It has eight external ports and they are labeled ext1 through ext8. It has 16
internal ports and they are labeled bay1 through bay16.
Table 1-5 shows the port mapping between the Cisco MDS 9000 Family and the Cisco Fabric Switch for
HP c-Class BladeSystem.
Ta b l e 1-5 Port Mapping Between the Cisco MDS 9000 Family and the Cisco Fabric Switch for HP
c-Class BladeSystem
Cisco MDS 9000 Family Port
Cisco Fabric Switch for HP
c-Class BladeSystem Port
Port Group
fc1/1 ext8 PortGroup 1
fc1/2 bay6
fc1/3 bay13
fc1/4 bay5
fc1/5 ext7 PortGroup 2
fc1/6 bay14
fc1/7 bay15
fc1/8 bay7
fc1/9 bay4 PortGroup 3
fc1/10 ext1
fc1/11 bay3
fc1/12 bay11
fc1/13 bay12 PortGroup 4
To Next Page
Loading...
Need help?
General