Send documentation comments to mdsfeedback-doc@cisco.com
22-165
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ips netsim
show ips netsim
To display a summary of the IP Network Simulator interface status currently operating, use the show ips
netsim command.
show ips netsim
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes EXEC.
Command History
Usage Guidelines None.
Examples The following example shows the IP Network Simulator interfaces operating in network simulation
mode.
switch# show ips netsim
Following ports operate in network simulator mode
GigabitEthernet2/3 and GigabitEthernet2/4
Related Commands
Release Modification
3.1(1) This command was introduced.
Command Description
ips netsim enable Enables two Gigabit Ethernet interfaces to operate in network simulation
mode.
To Next Page
Loading...
Need help?
General