Send documentation comments to mdsfeedback-doc@cisco.com
6-107
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug sdv
debug sdv
To enable debugging for SAN device virtualization, use the debug sdv command in EXEC mode.
debug sdv {all | all-sdv | ddas {errors | events} | ddas-config {errors | events | packets} |
discovery {errors vsan vsan-id | events vsan vsan-id} | distribution {errors vsan vsan-id |
events vsan vsan-id} | errors vsan vsan-id | fu {ha | transition} | mgmt {errors | events} | ns
{errors | events | packets} | rewrite {errors | events | packets} | trace vsan vsan-id |
virtual-domain {errors vsan vsan-id | events vsan vsan-id} | zone-activation {errors | events
| packets}}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
all Configures all SDV debugs.
all-sdv Configures all filters for SDV debugging.
ddas Enables the DDAS debugs.
errors Enables debugs for errors.
events Enables debugs for events.
ddas-config Enables the DDAS-CFG debugs.
packets Enables debugs for packets.
discovery Enables the Disc debugs.
vsan vsan-id Specifies the number of the VSAN. The range is 1 to 4093.
distribution Enables the Dist debugs.
errors Enables the Error debugs.
fu Enables the FU debugs.
ha Enables the FU HA debugs.
mgmt Enables the Config FSM debugs.
ns Enables the NS debugs.
rewrite Enables the Rewrite debugs.
trace Enables the Trace debugs.
virtual-domain Enables the Virtual Domain debugs.
zone-activation Enables the ZS-ACTV debugs.
Release Modification
3.1(2) This command was introduced.
To Next Page
Loading...
Need help?
General