Send documentation comments to mdsfeedback-doc@cisco.com
8-79
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
flex-attach virtual-pwwn interface
flex-attach virtual-pwwn interface
To set the user-specific FlexAttach virtual port WWN (pWWN) on an interface, use the flex-attach
virtual-pwwn interface command. To disable the virtual pWWN, use the no form of the command.
flex-attach virtual-pwwn vpwwn interface interface [vsan vsan]
no flex-attach virtual-pwwn vpwwn interface interface [vsan vsan]
Syntax Description
Defaults None.
Command Modes Configuration mode
Command History
Usage Guidelines None.
Examples The following example shows how to set the user-specific virtual pWWN on an interface.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch# (config) flex-attach virtual-pwwn 20:04:00:a0:b8:16:92:18 interface fc 1/1
Related Commands
vpwwn Specifies the virtual pWWN chosen by the user.
interface Specifies the interface on which the FlexAttach virtual port has to be
enabled.
Note The interface must be in the shut state.
vsan vsan Specifies the VSAN on which FlexAttach should be enabled.
Release Modification
3.3(1a) This command was introduced.
Command Description
flex-attach
virtual-pwwn auto
Enables the FlexAttach virtual pWWN on a specific interface.
To Next Page
Loading...
Need help?
General