Send documentation comments to mdsfeedback-doc@cisco.com
22-70
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show fc2
show fc2
To display FC2 information, use the show fc2 command.
show fc2 {bind | classf | exchange | exchresp | flogi | nport | plogi | plogi_pwwn | port [brief] |
socket | sockexch | socknotify | socknport | vsan}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays FC2 active socket information.
switch# show fc2 socket
SOCKET REFCNT PROTOCOL PID RCVBUF RMEM_USED QLEN NOTSK
b2a64b20 2 0 1421 65535 0 0 0
b2a647e0 3 0 1418 262142 0 0 0
b2a644a0 3 0 1417 65535 0 0 0
b2a64160 3 0 1417 262142 0 0 0
b294b180 3 0 1411 65535 0 0 0
b294ae40 3 0 1411 65535 0 0 0
bind Displays FC2 socket bindings.
classf Displays FC2 classf sessions.
exchange Displays FC2 active exchanges.
exchresp Displays FC2 active responder exchanges.
flogi Displays FC2 FLOGI table.
nport Displays FC2 local N ports.
plogi Displays FC2 PLOGI sessions.
plogi_pwwn Displays FC2 PLOGI pWWN entries.
port [brief] Displays FC2 physical port table.
socket Displays FC2 active sockets.
sockexch Displays FC2 active exchanges for each socket.
socknotify Displays FC2 local N port PLOGI/LOGO notifications for each socket.
socknport Displays FC2 local nports per each socket.
vsan Displays FC2 VSAN table.
Release Modification
1.0(2) This command was introduced.
To Next Page
Loading...
Need help?
General