Send documentation comments to mdsfeedback-doc@cisco.com
23-27
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
tcp keepalive-timeout
tcp keepalive-timeout
To configure the interval between which the TCP connection verifies if the FCIP link is functioning, use
the tcp keepalive-timeout
command. Use the no form of this command to disable this feature or revert
to its factory defaults.
tcp keepalive-timeout seconds
no tcp keepalive-timeout seconds
Syntax Description
Defaults 60 seconds.
Command Modes FCIP profile configuration submode.
Command History
Usage Guidelines This command can be used to detect FCIP link failures.
Examples The following example configures a FCIP profile:
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)#
The following example specifies the keepalive timeout interval for the TCP connection:
switch(config-profile)# tcp keepalive-timeout 120
Related Commands
seconds Specifies the time in seconds. The range is 1 to 7200.
Release Modification
1.1(1) This command was introduced.
Command Description
fcip profile Configures FCIP profile parameters.
show fcip profile Displays FCIP profile information.
To Next Page
Loading...
Need help?
General