CHAPTER
Send documentation comments to mdsfeedback-doc@cisco.com
6-1
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
6
Debug Commands
The commands in this chapter apply to the Cisco MDS 9000 Family of multilayer directors and fabric
switches. All debug commands are issued in EXEC mode and are shown here in alphabetical order. For
more information, refer to the Cisco MDS 9000 Family Troubleshooting Guide and the Cisco MDS 9000
Family System Messages Guide.
Using the CLI, you can enable debugging modes for each switch feature and view a real-time updated
activity log of the control protocol exchanges. Each log entry is time-stamped and listed in chronological
order. Access to the debug feature can be limited through the CLI roles mechanism and can be
partitioned on a per-role basis.
To Next Page
Loading...
Need help?
General