Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
18-40
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 18 P Commands
pwwn (DPVM database configuration submode)
pwwn (DPVM database configuration submode)
To add a device to a dynamic port VSAN membership (DPVM) database using the pWWN, use the
pwwn command in DPVM database configuration submode. To remove a device from a DPVM
database using the pWWN, use the no form of the command.
pwwn pwwn-id vsan vsan-id
no pwwn pwwn-id vsan vsan-id
Syntax Description
Defaults None.
Command Modes DPVM database configuration submode.
Command History
Usage Guidelines To use this command, DPVM must be enabled using the dpvm enable command.
Examples The following example shows how to add an entry to the DPVM database.
switch# config terminal
switch(config)# dpvm database
switch(config-dpvm-db)# pwwn 11:22:33:44:55:66:77:88 vsan 1
The following example shows how to delete an entry from the DPVM database.
switch(config-dpvm-db)# no pwwn 11:22:33:44:55:66:77:88 vsan 1
Related Commands
pwwn-id Specifies the port WWN ID. The format is hh:hh:hh:hh:hh:hh:hh, where h
is a hexadecimal number.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
2.0(x) This command was introduced.
Command Description
dpvm database Configures the DPVM database.
show dpvm Displays DPVM database information.