Send documentation comments to mdsfeedback-doc@cisco.com
6-129
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug wr-reg
debug wr-reg
To enable debugging for the list of devices using the write-register feature, use the debug wr-reg
command in EXEC mode. To disable a debug command, use the no form of the command or use the no
debug all command to turn off all debugging.
debug wr-reg [device-name | register-address]
no debug wr-reg [device-name | register-address]
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug wr-reg command is issued:
switch# debug wr-reg
Related Commands
device-name Specifies the device name for the required device.
register-address Specifies the register address for the required device.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
To Next Page
Loading...
