Send documentation comments to mdsfeedback-doc@cisco.com
22-229
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show line
The following example displays output from an MDS switch with a Supervisor-1 module.
switch# show line com1
line Aux:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:17 rx:0 Register Bits:RTS|DTR
The following example displays output from an MDS switch with a Supervisor-2 module.
switch# show line com1
line Aux:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q0V1&D0&C0S0=1\015
Statistics: tx:17 rx:0 Register Bits:RTS|DTR
Related Commands Command Description
line console Configure primary terminal line.
line aux Configures the auxiliary COM 1 port
clear line Deleted configured line sessions.
To Next Page
Loading...
Need help?
General