Send documentation comments to mdsfeedback-doc@cisco.com
14-24
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
logging timestamp
logging timestamp
To set the time increment for the message logging time stamp, use the logging timestamp command. To
negate the previously issued command or to revert to factory defaults, use the no form of the command.
logging timestamp {microseconds | milliseconds | seconds}
no logging timestamp {microseconds | milliseconds | seconds}
Syntax Description
Defaults Seconds.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example sets the logging time stamp to milliseconds.
switch## config terminal
switch(config)# logging timestamp milliseconds
Related Commands
microseconds Sets the logging time stamp to microseconds.
milliseconds Sets the logging time stamp to milliseconds.
seconds Sets the logging time stamp to seconds.
Release Modification
3.0(1) This command was introduced.
Command Description
show logging Displays logging configuration information.
To Next Page
Loading...
