Send documentation comments to mdsfeedback-doc@cisco.com
22-59
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show debug sme
show debug sme
To display all Cisco SME related debug commands configured on the switch, use the show debug
command.
show debug {cluster { bypass | sap sap } | sme bypass }
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows all debug commands configured on the switch.
switch# show debug
ILC helper:
ILC_HELPER errors debugging is on
ILC_HELPER info debugging is on
Related Commands
cluster Displays all the debugging flags .
bypass Displays the bypass flags.
sap sap Displays all debugging flags of SAP. Specifies the SAP in the range from
1-65535
sme Displays all the debugging flags of Cisco SME.
bypass Displays all the bypass flags of Cisco SME.
Release Modification
3.2(2) This command was introduced.
Commands Description
debug sme Debugs Cisco SME features.
To Next Page
Loading...
Need help?
General