Send documentation comments to mdsfeedback-doc@cisco.com
11-47
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ip address (interface configuration)
ip address (interface configuration)
To assign an IP address to a Gigabit Ethernet interface, use the ip address command in interface
configuration submode. To remove the IP address, us the no form of the command.
ip address address netmask
no ip address address netmask
Syntax Description
Defaults None.
Command Modes Interface configuration submode.
Command History
Usage Guidelines None.
Examples The following example assigns an IP address to a Gigabit Ethernet interface.
switch# config terminal
switch(config)# interface gigabitethernet 1/2
switch(config-profile)# ip address 10.5.1.1 255.255.0.0
Related Commands
address Specifies the IP address.
netmask Specifies the network mask.
Release Modification
1.1(2) This command was introduced.
Command Description
show fcip profile Displays information about the FCIP profile.
interface fcip
interface_number
use-profile profile-id
Configures the interface using an existing profile ID from 1 to 255.
show interface fcip Displays an interface configuration for a specified FCIP interface.
To Next Page
Loading...
Need help?
General