Send documentation comments to mdsfeedback-doc@cisco.com
22-123
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show flogi
show flogi
To list all the FLOGI sessions through all interfaces across all VSANs, use the show flogi command.
show flogi {auto-area-list} | database {fcid fcid-id | interface {fa slot/port | fc slot/port | fv
module-number} | vsan vsan-id}
Note On a Cisco Fabric Switch for HP c-Class BladeSystem and on a Cisco Fabric Switch for IBM
BladeCenter, the syntax differs as follows:
interface {bay port | ext port}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines Output of this command is first sorted by interface and then by VSANs.
auto-area-list Displays the list of OUIs that are allocated areas.
database Displays information about FLOGI sessions.
fcid fcid-id Displays FLOGI database entries based on the FCID allocated. The format
is 0xhhhhhh.
interface Displays FLOGI database entries based on the logged in interface.
fa slot/port Specifies the FA port interface to configure by slot and port number on all
switches.
fc slot/port (Optional) Specifies the Fibre Channel interface to configure by slot and
port number on an MDS 9000 Family switch.
bay port | ext port (Optional) Specifies the Fibre Channel interface by bay or by external port
on a Cisco Fabric Switch for HP c-Class BladeSystem or on a Cisco Fabric
Switch for IBM BladeCenter. The range is 0 to 48.
fv module-number Specifies the Fibre Channel Virtualization interface by module on all
switches.
vsan vsan-id Displays FLOGI database entries based on the VSAN ID. The range is
1 to 4093.
Release Modification
1.0(2) This command was introduced.
3.1(2) Added the interface bay | ext option.
To Next Page
Loading...
