Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
20-11
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
radius-server timeout
radius-server timeout
To specify the time between retransmissions to the RADIUS servers, use the radius-server timeout
command. You can revert the retransmission time to its default by issuing the no form of the command.
radius-server timeout seconds
no radius-server timeout seconds
Syntax Description
Defaults 1 second
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example configures the timeout value to 30 seconds.
switch# config terminal
switch(config)# radius-server timeout 30
Related Commands
seconds Specifies the time (in seconds) between retransmissions to the RADIUS
server. The range is 1 to 60 seconds.
Release Modification
1.0(2) This command was introduced.
Command Description
show radius-server Displays RADIUS server information.