Send documentation comments to mdsfeedback-doc@cisco.com
21-31
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
site-id
site-id
To configure the site ID with the Call Home function, use the site-id command in Call Home
configuration submode. To disable this feature, use the no form of the command.
site-id {site-number}
no site-id {site-number}
Syntax Description
Defaults None.
Command Modes Call Home configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure the site ID in the Call Home configuration.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# site-id Site1ManhattanNY
Related Commands
site-number Identifies the unit to the outsourced throughput. Allows up to 256
alphanumeric characters in free format.
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.
To Next Page
Loading...
Need help?
General