Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-225
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show kernel core
show kernel core
To display kernel core configuration information, use the show kernel core command.
show kernel core {limit | module slot | target}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following examples display kernel core settings.
switch# show kernel core limit
2
switch# show kernel core target
10.50.5.5
switch# show kernel core module 5
module 5 core is enabled
level is header
dst_ip is 10.50.5.5
src_port is 6671
dst_port is 6666
dump_dev_name is eth1
dst_mac_addr is 00:00:0C:07:AC:01
limit Displays the configured line card limit.
module slot Displays the kernel core configuration for a module in the specified slot.
target Displays the configured target IP address.
Release Modification
1.1(1) This command was introduced.