Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-333
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show span session
show span session
To display specific information about a SPAN session, use the show span session command.
show span session [session-id [brief] | brief]
Syntax Description
Defaults None.
Command Modes EXEC mode
Command History
Usage Guidelines None.
Examples The following example displays SPAN sessions in a brief format.
switch# show span session brief
--------------------------------------------------------
Session Admin Oper Destination
State State Interface
--------------------------------------------------------
7 no suspend active fc2/7
The following example displays specific SPAN session details.
switch# show span session 7
Session 7 (active)
Destination is fc2/7
No session filters configured
Ingress (rx) sources are
fc1/5,
Egress (tx) sources are
fc1/5,
switch# show span session 7
Session 7 (active)
Destination is fc-tunnel 100
No session filters configured
Ingress (rx) sources are
fc1/5,
Egress (tx) sources are
fc1/5,
session-id Specifies the SPAN session ID. The range is 1 to 16.
brief Displays the SPAN session configuration in a brief format.
Release Modification
1.2(1) This command was introduced.
3.3(1a) Added support for SPAN traffic in both ingress and egress directions.