Send documentation comments to mdsfeedback-doc@cisco.com
22-162
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ips ip route
show ips ip route
To show the IP storage route table information, use the show ips ip route command.
show ips ip route interface gigabitethernet slot/port
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the IP route table information for a Gigabit Ethernet interface.
switch# show ips ip route interface gigabitethernet 8/1
Codes: C - connected, S - static
No default gateway
C 10.1.3.0/24 is directly connected, GigabitEthernet8/1
interface gigabitethernet slot/port Specifies a Gigabit Ethernet interface by the slot and port.
Release Modification
1.1(1) This command was introduced.
To Next Page
Loading...
Need help?
General