Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
11-27
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface fcip
interface fcip
To configure a Fibre Channel over IP Protocol (FCIP) interface, use the interface fcip command. To
disable a FCIP interface, use the no form of the command.
interface fcip interface_number
bport
bport-keepalives
channel-group number [force]
fcdomain rcf-reject vsan vsan-id
ficon portnumber portnumber |
fspf {cost link-cost | dead-interval seconds | hello-interval seconds | passive |
retransmit-interval seconds} vsan vsan-id
passive-mode
peer-info ipaddr ip-address [port number]
qos control control-value data data-value
special-frame peer-wwn pwwn-id
tcp-connections number
time-stamp [acceptable-diff number]
use-profile profile-id
interface fcip interface_number
no bport
no bport-keepalives
no channel-group number [force]
no fcdomain rcf-reject vsan vsan-id
no ficon portnumber portnumber
no fspf {cost link-cost | dead-interval seconds | hello-interval seconds | passive |
retransmit-interval seconds} vsan vsan-id
no qos control-value data data-value
no passive-mode
no peer-info ipaddr ip-address [port number]
no special-frame peer-wwn pwwn-id
no tcp-connections number
no time-stamp [acceptable-diff number]
no use-profile profile-id
Syntax Description interface-number Configures the specified interface from 1 to 255.
bport Sets the B port mode.
bport-keepalives Sets the B port keepalive responses.
channel-group number Specifies a PortChannel number from 1 to 128.
force Forcefully adds a port.
fcdomain Enters the fcdomain mode for this FCIP interface
rcf-reject Configures the rcf-reject flag.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
fspf Configures FSPF parameters.
cost link-cost Enters FSPF link cost. The range is 1 to 65535
dead-interval seconds Specifies the dead interval in seconds. The range is 1 to 65535.