Send documentation comments to mdsfeedback-doc@cisco.com
18-34
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 18 P Commands
priority
priority
To configure the priority in a QoS policy map class, use the priority command in QoS policy class map
configuration submode. To disable this feature, use the no form of the command.
priority {high | low | medium}
no priority {high | low | medium}
Syntax Description
Defaults The default priority is low.
Command Modes QoS policy map class configuration submode.
Command History
Usage Guidelines Before you can configure the priority in a QoS policy map class you must first:
• Enable the QoS data traffic feature using the qos enable command.
• Configure a QoS class map using the qos dwrr-q command.
• Configure a QoS policy map using the qos policy-map command.
• Configure a QoS policy map class using the class command.
Examples The following example shows how to select the QoS policy class-map1 and configure the frame priority
as high.
switch(config-pmap)# class class-map1
switch(config-pmap-c)# priority high
Operation in progress. Please check class-map parameters
switch(config-pmap-c)#
Related Commands
high Configures the frames matching the class-map as high priority.
low Configures the frames matching the class-map as low priority. The default.
medium Configures the frames matching the class-map as medium priority.
Release Modification
1.3(1) This command was introduced.
Command Description
qos enable Enables the QoS data traffic feature on the switch.
qos class-map Configures a QoS class map.
qos policy-map Configure a QoS policy map.
To Next Page
Loading...
Need help?
General