Send documentation comments to mdsfeedback-doc@cisco.com
22-349
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show system default zone
show system default zone
To verify the configured default zone values, use the show system default zone command.
show system default zone
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows the default values for default-zone as deny, distribute as active only, and
zone mode as basic.
switch# show system default zone
system default zone default-zone deny
system default zone distribute active only
system default zone mode basic
The following example shows the default values for default-zone as permit, distribute as full, and zone
mode as enhanced.
switch# show system default zone
system default zone default-zone permit
system default zone distribute active full
system default zone mode enhanced
Related Commands
This command has no other arguments or keywords.
Release Modification
3.0(1) This command was introduced.
3.2(1) Added the basic default zoning mode option.
Command Description
system default zone
mode enhanced
Configures the default value of zone mode as enhanced.
no system default zone
mode enhanced
Configures the default value of zone mode as basic.
system default zone
distribute full
Configures the default value of distribute as full.
To Next Page
Loading...
Need help?
General