Send documentation comments to mdsfeedback-doc@cisco.com
6-82
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug ntp
debug ntp
To enable debugging for the Network Time Protocol (NTP) module, use the debug ntp command in
EXEC mode. To disable a debug command, use the no form of the command or use the no debug all
command to turn off all debugging.
debug ntp {errors | info}
no debug ntp {errors | info}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug ntp info command is issued:
switch# debug ntp info
2005 Mar 10 03:00:42 ntp: Dropping msg_ref with rr_token [7002722]
Related Commands
errors Enables debugging for NTP error conditions.
info Enables debugging for NTP information and events.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
show ntp Displays the configured NTP server and peer associations.
To Next Page
Loading...
Need help?
General