Send documentation comments to mdsfeedback-doc@cisco.com
6-75
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug license
debug license
To enable licensing debugging, use the debug license command in EXEC mode. To disable a debug
command, use the no form of the command or use the no debug all command to turn off all debugging.
debug license {all | errors | event s | mts}
no debug license {all | errors | events | mts}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug license all command is issued:
switch# debug license all
Related Commands
all Enables debugging for all licensing features.
errors Enables debugging for licensing error conditions.
events Enables debugging for the licensing events.
mts Enables debugging for Tx/Rx packets of MTS.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
show license Displays license information.
To Next Page
Loading...
Need help?
General