Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
23-12
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
tacacs-server timeout
tacacs-server timeout
To specify the time between retransmissions to the TACACS+ servers, use the tacacs-server timeout
command. You can revert the retransmission time to its default by issuing the no form of the command.
tacacs-server timeout seconds
notacacs-server timeout seconds
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines This command is only available when the TACACS+ feature is enabled using the tacacs+ enable
command.
Examples The following example configures the TACACS+ server timeout value.
switch# config terminal
switch(config)# tacacs-server timeout 30
Related Commands
seconds Specifies the time (in seconds) between retransmissions to the RADIUS
server. The default is one (1) second and the valid range is 1 to 60 seconds.
Release Modification
1.3(2) This command was introduced.
Command Description
show tacacs-server Displays TACACS+ server information.
tacacs+ enable Enable TACACS+.