Send documentation comments to mdsfeedback-doc@cisco.com
7-2
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 7 E Commands
email-contact
email-contact
To configure an e-mail contact with the Call Home function, use the email-addr command in Call Home
configuration submode. To disable this feature, use the no form of the command.
email-addr email-address
no email-addr email-address
Syntax Description
Defaults None.
Command Modes Call Home configuration submode
Command History
Usage Guidelines None.
Examples The following example shows how to configure e-mail contact in the Call Home configuration.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# email-contact username@company.com
Related Commands
email-address Configures an e-mail address. Uses a standard e-mail address that does not
have any text size restrictions.
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.
To Next Page
Loading...
