Send documentation comments to mdsfeedback-doc@cisco.com
7-3
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 7 E Commands
enable
enable
To enable the Call Home function, use the enable command in Call Home configuration submode. To
disable this feature, use the disable command.
enable
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes Call Home configuration submode.
Command History
Usage Guidelines To disable the Call Home function, use the disable command.
Examples The following example shows how to enable the Call Home function.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# enable
Related Commands
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.
To Next Page
Loading...
Need help?
General