Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-89
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show fcip
show fcip
To display FCIP profile information, use the show fcip command.
show fcip {host-map fcip-id | profile [profile-id | all] | summary | tape-session {summary | tunnel
tunnel-id {host-end | target-end}} | target-map fcip-id | wa-login-list tunnel-id}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays all FCIP profiles.
switch# show fcip profile all
----------------------------------------------------
ProfileId Ipaddr TcpPort
----------------------------------------------------
1 41.1.1.2 3225
2 10.10.100.154 3225
3 43.1.1.2 3225
4 44.1.1.100 3225
host-map fcip-id Displays the information for a specified map. The range is 1 to 255.
profile Displays the information for a profile.
profile-id Specifies the profile ID. The range is 1 to 255.
all Specifies all profile IDs.
summary Displays summary information.
tape-session Displays tape session information.
tunnel tunnel-id Displays information for a specified FCIP tunnel ID. The range is 1 to 255.
host-end Displays information for the host end.
target-end Displays information for the target end.
target-map fcip-id Displays information for a specified target map. The range is 1 to 255.
wa-login-list tunnel-id Displays the write acceleration login list for a specified FCIP tunnel ID. The
range is 1 to 255.
Release Modification
1.1(1) This command was introduced.
2.0(x) Added the host-map, summary, and target-map keywords.
3.0(1) Added the tape-session, tunnel, host-end, target-end, and wa-login-list
keywords.