Send documentation comments to mdsfeedback-doc@cisco.com
22-222
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ivr service-group
show ivr service-group
To display an inter-VSAN routing (IVR) service groups, use the show ivr service-group command.
show ivr service-group [active | configured]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines You can configure a maximum of 16 IVR service groups.
Examples The following example displays IIVR service groups.
switch# show ivr service-group
IVR CONFIGURED Service Group
====================================
SG-ID SG-NAME AFID VSANS
------------------------------------------------------------------------------
1 sg-100 1 200-201,250,270
2 sg-200 1 100-101,150,170
Total: 2 entries in configured service group table
IVR ACTIVE Service Group
====================================
SG-ID SG-NAME AFID VSANS
------------------------------------------------------------------------------
1 sg-100 1 200-201,250,270
2 sg-200 1 100-101,150,170
Total: 2 entries in active service group table
Related Commands
active Displays active IVR service groups.
configured Displays configured IVR service groups.
Release Modification
3.0(1) This command was introduced.
Command Description
clear ivr service-group
database
Clears an IVR service group database.
ivr service-group
name
Configures an IVR service group.
To Next Page
Loading...
Need help?
General