Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-305
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show san-ext-tuner
show san-ext-tuner
To display SAN extension tuner information, use the show san-ext-tuner command.
show san-ext-tuner {interface gigabitethernet slot/port [nport pwwn pwwn-id vsan vsan-id
counters] | nports}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows how to display SAN extension tuner N port information.
switch# show san-ext-tuner nports
Related Commands
interface Displays SAN extension tuner information for a specific Gigabit Ethernet
interface.
gigabitethernet slot/port Specifies a Gigabit Ethernet interface.
nport Specifies an N port.
pwwn pwwn-id Specifies a pWWN ID. The format is hh:hh:hh:hh:hh:hh:hh:hh, where h is
a hexadecimal number.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
counters Specifies SAN extension tuner counters.
nports Displays SAN extension tuner information for all nports.
Release Modification
2.0(x) This command was introduced.
Command Description
san-ext-tuner Enters SAN extension tuner configuration mode.