Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
21-50
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
span max-queued-packets
span max-queued-packets
To configure the SPAN max-queued-packets, use the span max-queued-packets command in
configuration mode.To disable the SPAN drop-threshold, use the no form of the command.
span max-queued-packets id
Syntax Description
Defaults 15.
Command Modes Configuration mode
Command History
Usage Guidelines This command is supported only on a ISOLA platform.
Examples The following example shows how to configure the SPAN max-queued-packets.
switch#config
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# span max-queued-packets 1
Related Commands
id Specifies the SPAN max-queued-packets threshold ID. The range is 1 to
8191.
Release Modification
3.3(1a) This command was introduced.
Command Description
show span
max-queued-packets
Displays the SPAN max-queued-packets.
show span
drop-counters
Displays the SPAN drop-counters.