Send documentation comments to mdsfeedback-doc@cisco.com
4-25
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
cimserver loglevel
cimserver loglevel
To configure the cimserver loglevel filter, use the cimsever loglevel command in configuration mode.
cimserver loglevel filter value
Syntax Description
Defaults None.
Command Modes Configuration mode
Command History
Usage Guidelines None.
Examples The following example displays the cimserver loglevel.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# cimserver loglevel 2
Current value for the property logLevel is set to "INFORMATION" in CIMServer.
Related Commands
filter value Specifies the cimserver log filter levels. The range is 1 to 5.
1 Sets the current value for the loglevel property to trace.
2 Sets the current value for the loglevel property to information.
3 Sets the current value for the loglevel property to warning.
4 Sets the current value for the loglevel property to severe.
5 Sets the current value for the loglevel property to fatal.
Release Modification
3.3(1a) This command was introduced.
Command Description
show cimserver logs Displays the cimserver logs.
To Next Page
Loading...
Need help?
General