Send documentation comments to mdsfeedback-doc@cisco.com
5-46
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 5 D Commands
dpvm enable
dpvm enable
To enable dynamic port VSAN membership (DPVM), use to dpvm enable command. To disable DPVM,
use the no form of the command.
dpvm enable
no dpvm enable
Syntax Description This command has no other arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines The configuration and verification commands for DPVM are only available when DPVM is enabled on
the switch. When you disable this feature, all related configurations are automatically discarded.
Examples The following example shows how to enable DPVM.
switch# config terminal
switch(config)# dpvm enable
Related Commands
Release Modification
2.0(x) This command was introduced.
Command Description
dpvm activate Activates the DPVM database.
dpvm database Configures the DPVM database.
show dpvm Displays DPVM database information.
To Next Page
Loading...
Need help?
General