Send documentation comments to mdsfeedback-doc@cisco.com
22-155
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ip arp
show ip arp
To display IP neighbors for the system, use the show ip arp command.
show ip arp [interface {cpp module-number | gigabitethernet slot/port | mgmt | vsan vsan-id}]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays IP neighbor information.
switch# show ip arp
IP Address Age(min) Link-layer Addr Type Interface
10.10.10.100 0 0006.d623.4008 ARPA GigabitEthernet1/1
10.10.10.9 5 0002.b3d9.ba6f ARPA GigabitEthernet1/1
10.10.10.16 11 0004.23bd.677b ARPA GigabitEthernet1/1
172.22.31.1 67 0000.0c07.ac01 ARPA mgmt0
172.22.31.2 0 000e.d68f.c3fc ARPA mgmt0
172.22.31.3 0 000e.d68f.43fc ARPA mgmt0
172.22.31.250 1067 00e0.8152.7f8d ARPA mgmt0
Related Commands
interface Displays the IP neighbors for a specified interface.
cpp module-number Specifies the virtualization IP over Fibre Channel (IPFC) interface by
control plane processor (CPP) module number. The range is 1 to 6.
gigabitethernet slot/port Specifies the Gigabit Ethernet interface by slot and port number. The
range is 1 to 6.
mgmt Specifies the management interface.
vsan vsan-id Specifies the IPFC VSAN interface by VSAN ID. The range is 1 to 4093.
Release Modification
3.0(1) This command was introduced.
Command Description
show ip interface Displays IP interface status and configuration information.
show ip traffic Displays IP protocol statistics for the system.
To Next Page
Loading...
Need help?
General