Send documentation comments to mdsfeedback-doc@cisco.com
11-143
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ivr zone name
ivr zone name
To configure a zone for Inter-VSAN Routing (IVR), use the ivr zone name command. To disable a zone
for IVR, use the no form of the command.
ivr zone name ivzs-name
no ivr zone name ivz-name
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines This command enters IVR zone configuration submode.
Examples The following command enters the configuration mode, enables the IVR feature, creates an IVZ, and
adds a pWWN-VSAN member.
switch# config terminal
switch(config)# ivr enable
switch(config)# ivr zone name Ivz_vsan2-3
switch(config-ivr-zone)# member pwwn 21:00:00:e0:8b:02:ca:4a vsan 3
Related Commands
ivz-name Specifies the IVZ name. Maximum length is 59 characters.
Release Modification
1.3(1) This command was introduced.
Command Description
show ivr Displays IVR feature information.
To Next Page
Loading...
Need help?
General