Send documentation comments to mdsfeedback-doc@cisco.com
22-160
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ip traffic
show ip traffic
To display IP protocol statistics for the system, use the show ip traffic command.
show ip traffic [interface gigabitethernet slot/port]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays IP protocol statistics for the Gigabit Ethernet interface.
switch# show ip traffic interface gigabitethernet 2/2
IP Statistics for GigabitEthernet2/2
Rcvd: 0 total, 0 local destination
0 errors, 0 unknown protocol, 0 dropped
Sent: 30 total, 0 forwarded 0 dropped
Frags: 0 reassembled, 0 timeouts, 0 couldn't reassemble
0 fragmented, 0 fragments created, 0 couldn't fragment
ICMP Statistics:
Rcvd: 0 total, 0 errors, 0 unreachables, 0 time exceeded
0 echo, 0 echo reply, 0 mask requests, 0 mask replies
0 redirects, 0 timestamp requests, 0 timestamp replies
Sent: 0 total, 0 errors, 0 unreachables, 0 time exceeded
0 echo, 0 echo reply, 0 mask requests, 0 mask replies
0 redirects, 0 timestamp requests, 0 timestamp replies
Related Commands
interface Displays the IP neighbors for a specified interface.
gigabitethernet slot/port Specifies the Gigabit Ethernet interface by slot and port number. The
range is 1 to 6.
Release Modification
3.0(1) This command was introduced.
Command Description
show ip arp Displays IP neighbors for the system.
show ip interface Displays IP interface status and configuration information.
To Next Page
Loading...
Need help?
General