Send documentation comments to mdsfeedback-doc@cisco.com
22-295
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show rmon
show rmon
To display the remote monitoring (RMON) configuration or onboard log, use the show rmon command.
show rmon {alarms | events | hcalarms | logs}
Syntax Description
Defaults None.
Command Modes EXEC mode
Command History
Usage Guidelines None.
Examples The following example displays the configured RMON alarms.
switch# show rmon alarms
Alarm 20 is active, owned by test
Monitors 1.3.6.1.2.1.2.2.1.16.30 every 30 second(s)
Taking delta samples, last value was 17
Rising threshold is 15, assigned to event 1
Falling threshold is 0, assigned to event 0
On startup enable rising or falling alarm
The following example displays the configured RMON events.
switch# show rmon events
Event 4 is active, owned by administrator@london_op_center
Description is WARNING(4)
Event firing causes log and trap to community public, last fired 03:32:43
alarms Displays the configured 32-bit RMON alarms.
events Displays the configured RMON events.
hcalarms Displays the configured 64-bit high-capacity (HC) RMON alarms.
logs Displays the RMON event logs.
Release Modification
2.0(x) This command was introduced.
2.1(2) Added the logs option.
3.0(1) Added the hcalarms option.