Send documentation comments to mdsfeedback-doc@cisco.com
2-5
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
aaa authentication iscsi default
aaa authentication iscsi default
To configure the iSCSI authentication method, use the aaa authentication iscsi default command in
configuration mode. To negate the command or revert to factory defaults, use the no form of this
command.
aaa authentication iscsi default {group group-name [none] | none} | local [none] | none}}
no aaa authentication iscsi default {group group-name [none] | none} | local [none] | none}}
Syntax Description
Defaults Local user name authentication.
Command Modes Configuration mode.
Command History
Usage Guidelines The local option disables other authentication methods and configures local authentication to be used
exclusively.
Specify the currently configured command preceded by a no in order to revert to the factory default.
Examples The following example enables all iSCSI authentication to be performed using remote TACACS+ servers
which are member of the group called TacServers, followed by the local authentication.
switch# config terminal
switch(config)# aaa authentication iscsi default group TacServer
The following example reverts to the local authentication method (default).
switch(config)# no aaa authentication iscsi default group TacServer
Related Commands
group group-name Specifies the group name. The group name is a maximum of 127 characters.
local Specifies local user name authentication (default).
none Specifies no authentication.
Release Modification
1.3(1) This command was introduced.
Command Description
show aaa authentication Displays the configured authentication methods.
To Next Page
Loading...
Need help?
General