Send documentation comments to mdsfeedback-doc@cisco.com
8-2
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fabric
fabric
To add a fabric to the cluster, use the fabric command in the Cisco SME cluster configuration submode.
fabric fabric name
Syntax Description
Defaults None.
Command Modes Cisco SME cluster configuration submode.
Command History
Usage Guidelines None.
Examples The following example adds a fabric named sw-xyz to a cluster:
switch# config terminal
switch(config)# sme cluster c1
switch(config-sme-cl)# fabric sw-xyz
Related Commands
fabric name Specifies the fabric name. The maximum length is 32 characters.
Release Modification
3.2(2) This command was introduced.
Command Description
show sme cluster Displays information about Cisco SME cluster.
To Next Page
Loading...
Need help?
General