Send documentation comments to mdsfeedback-doc@cisco.com
21-15
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
sdv enable
sdv enable
To enable SDV on the switch, use the sdv enable command in configuration mode. To disable SDV, use
the no form of the command.
sdv enable
no sdv enable
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example shows how to enable SDV.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv enable
The following example shows how to disable SDV.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# no sdv enable
Related Commands
Release Modification
3.1(2) This command was introduced.
Command Description
show sdv database Displays the SDV database.
show vritual-device Displays the virtual devices.
To Next Page
Loading...
Need help?
General