Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
21-64
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
stop
stop
To stop SCSI commands in progress on a SAN tuner extension N port, use the stop command.
stop {all | command-id cmd-id}
Syntax Description
Defaults None.
Command Modes SAN extension N port configuration submode.
Command History
Usage Guidelines None.
Examples The following example stops all SCSI command on a SAN extension tuner N port.
switch# san-ext-tuner
switch(san-ext)# nWWN 10:00:00:00:00:00:00:00
switch(san-ext)# nport pwwn 12:00:00:00:00:00:00:56 vsan 13 interface gigabitethernet
1/2
switch(san-ext-nport)# stop all
The following example stops a specific SCSI command on a SAN extension tuner N port.
switch# san-ext-tuner
switch(san-ext)# nWWN 10:00:00:00:00:00:00:00
switch(san-ext)# nport pwwn 12:00:00:00:00:00:00:56 vsan 13 interface gigabitethernet
1/2
switch(san-ext-nport)# stop command-id 100
Related Commands
all Stops all SCSI commands.
command-id cmd-id Stops a specific SCSI command identified by the command number. The
range is 0 to 2147483647.
Release Modification
2.0(1b) This command was introduced.
Command Description
nport pwwn Configures a SAN extension tuner N port.
read command-id Configures a SCSI read command for a SAN extension tuner N
port.
san-ext-tuner Enables the SAN extension tuner feature.
show san-ext-tuner Displays SAN extension tuner information.
write command-id Configures a SCSI write command for a SAN extension tuner N
port.