Send documentation comments to mdsfeedback-doc@cisco.com
21-63
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
static (iSCSI initiator configuration and iSLB initiator configuration)
The following example uses the switch WWN pool to allocate two pWWNs for this iSCSI initiator and
to keep it persistent.
switch(config-iscsi-init)# static pWWN system-assign 2
The following example shows a system-assigned pWWN for an iSLB initiator.
switch# config t
switch(config)# islb initiator ip-address 100.10.10.10
switch(config-islb-init)# static pwwn system-assign 4
The following example removes the system-assigned pWWN for the iSLB initiator.
switch (config-islb-init)# no static pwwn system-assign 4
Related Commands Command Description
iscsi initiator name Assigns an iSCSI name and changes to iSCSI initiator configuration
submode.
show iscsi initiator Displays information about configured iSCSI initiators.
show iscsi initiator
configured
Displays iSCSI initiator information for the configured iSCSI initiator.
show iscsi initiator
detail
Displays detailed iSCSI initiator information.
show iscsi initiator
summary
Displays iSCSI initiator summary information.
islb initiator Assigns an iSLB name and IP address to the iSLB initiator and enters iSLB
initiator configuration submode.
show islb initiator Displays iSLB initiator information.
show islb initiator
configured
Displays iSLB initiator information for the specified configured initiator.
show islb initiator detail Displays detailed iSLB initiator information.
show islb initiator
summary
Displays iSLB initiator summary information.
To Next Page
Loading...
Need help?
General