Send documentation comments to mdsfeedback-doc@cisco.com
18-14
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 18 P Commands
port-channel persistent
port-channel persistent
To convert an autocreated PortChannel to a persistent PortChannel, use the port-channel persistent
command in EXEC mode.
port-channel port-channel-id persistent
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This command is not reversible. A user-created channel group cannot be converted to an autocreated
channel group.When the port-channel persistent command is applied to an autocreated channel group,
the channel group number does not change and the member ports properties change to those of a
user-created channel group. The channel mode remains active.
Examples The following example shows how to change the properties of an autocreated channel group to a
persistent channel group.
switch# port-channel 10 persistent
Related Commands
port-channel-id Specifies the port channel ID. The range is 1 to 128.
Release Modification
2.0(x) This command was introduced.
Command Description
port-channel protocol Enables the PortChannel protocol.
show interface port-channel Displays PortChannel interface information.
show port-channel Displays PortChannel information.
To Next Page
Loading...
