Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
6-64
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug ipfc
debug ipfc
To enable IP over Fibre Channel (IPFC) debugging, use the debug ipfc command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
debug ipfc {all | errors | events | info | kernel {errors | events}}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug ipfc kernel errors command is
issued:
switch# debug ipfc kernel errors
Related Commands
all Enables debugging for all IPFC features.
errors Enables debugging for IPFC error conditions.
events Enables debugging for IPFC tx/rx MTS events.
info Enables debugging for IPFC information.
kernel Enables debugging for IPFC kernel operations.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.