Send documentation comments to mdsfeedback-doc@cisco.com
6-15
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug cimserver
debug cimserver
To enable debugging for the Common Information Model (CIM) management applications function, use
the debug cimserver command in EXEC mode. To disable a debug command use the no form of the
command or use the no debug all command to turn off all debugging.turn off all debugging).
debug cimserver {all | errors | events | mts | trace}
no debug cimserver {all | errors | events | mts | trace}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug cimserver all command is issued:
switch# debug cimserver all
2004 Mar 29 20:05:22 cimsrvprov: cim_mts_dispatch(): Opcode is 182
Related Commands
all Enables debugging for all CIM features.
errors Enables debugging for CIM error conditions.
events Enables debugging for CIM events.
mts Enables debugging for CIM tx/rx MTS packets.
trace Enables debugging for CIM traces.
Release Modification
1.3(1) This command was introduced.
Command Description
no debug all Disables all debugging.
show cimserver Displays the CIM configurations and settings.
To Next Page
Loading...
Need help?
General